弹出式卡盒（直接打印）

This is my own design of a pop up card wallet, is uses a front swipe motion to access the cards. I made it print-in-place so that it is easier and ready to use right out of the printer.
The design is simple and minimalistic, focused around ease of use.

Although it is print in place, it requires some pressing and forcing to free the movement.

The cards are held in place thanks to the 2 front slots that takes advantage of the plastic’s elasticity to keep them form falling out even upside down. I sliced the retention mechanism in 2 (with the groove on the side that is not straight) to prevent having one large card that stretches out all the plastic and lets go of all the other cards.

Printing :

• I recommend printing in PETG (PLA tends to lose the tension with the cards over time)
• Nozzle : 0.4mm
• layer height : 0.2mm
• no support

Print the model upright :

弹出式卡片钱包，它使用正面刷卡的动作来存取卡片。我把它做成了就地打印，这样它就更容易了，而且一出打印机就可以使用。
设计是简单和简约的，主要是为了方便使用。

虽然它是就地打印的，但它需要一些按压和强制的动作来释放。

卡片被固定在适当的位置，这要归功于前面的两个插槽，它利用了塑料的弹性，使它们即使倒置也不会掉出来。我把固定机制切成两半（凹槽在不直的一边），以防止有一张大的卡片把所有的塑料拉出来，让所有其他的卡片掉出来。

打印:
建议用PETG打印（PLA往往会随着时间的推移失去与卡片的张力）
喷嘴 : 0.4mm
层高 : 0.2mm
无支撑
直立打印该模型:

How to free the mechanism :
After the print is done, press on the pivot in the back of the wallet to free the mechanism :

Press it in different directions, you should hear some clics from the parts coming apart.
(you can press quit hard if needed)

I made an extra 2 holes in the back to better detach the mechanism, you can push with a screwdriver head to free the pieces.

Also free up the front strip and then you can force a bit and it should make it move.

It is a bit rough at the start but move it several times all the way to smooth the movement.

释放机制:
打印完成后，按压钱包后面的转轴，以释放机构。

从不同的方向按压，你应该听到一些零件分离的咔嚓声。
(如果需要，你可以不用力按）

我在后面多开了2个孔，以便更好地分离机械装置，你可以用螺丝刀头来推动，以释放这些部件。

同时释放出前面的条状物，然后你可以用力推一下，应该可以使它移动。

开始时有点粗糙，但一直移动几次，就能使运动平稳。